1. Open low point drain on fresh water tank

  2. Open both low point drains below water heater.

  3. Open all three shut-off valves on water heater.

  4. Wait for all water to drain from fresh water tank and water heater (water will stop flowing under trailer).

  5. Close all low point drains.

  6. Close water heater by-pass as follows.

  7. Disconnect water line coupler (break in water line near or above fresh water  tank).

  8. Hook antifreeze hose (supplied with trailer) to the water line coupler.

  9. Place open end of hose into antifreeze and turn on water pump.  Run all  faucets, toilet, outside spigot and shower (both hot and cold separately) until
         Be sure to run hot and cold antifreeze  flows from each.  .

  10. Unhook antifreeze hose and reconnect coupler.  Then turn off pump (pu8mp does not need to be disconnected.

  11. Pour about 2 cups of antifreeze down each drain (all sinks and shower).   This action will fill each trap.

 

June 2002    If you have questions be sure to contact Cutter Conversions